Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

AC/DC Module Boundary Condition

Posted Dec 18, 2012, 8:39 p.m. EST Low-Frequency Electromagnetics 0 Replies

Frank Sugden
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am currently working on a project to model a section view of a human forearm. The model terminates just before the elbow and the boundary condition there is a problem for me. I currently have the cut-off as a forced voltage port in the boundary conditions. I am working on COMSOL 3.5 and can't seem to understand the various options for boundary conditions. What would be ideal is to allow the simulation to determine voltage along the boundary, am I on the right track?

Frank
0 Replies Last Post Dec 18, 2012, 8:39 p.m. EST
COMSOL Moderator

Hello Frank Sugden

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content