Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Livelink for MATLAB taking too much time to simulate

Posted May 13, 2024, 7:46 a.m. EDT Electromagnetics, LiveLink for MATLAB, Geometry Version 6.0 1 Reply

Poonam Chand
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear all,

    I am simulating coil strands to know its AC resistance. i am using LiveLink for MATLAB to automate this task. however, for 10 turns coil with 100 strands, the total simulation time goes to 5 hours while for 10 turns with 300 strands, the total simulation time goes 50+ hours.
    by profiler code checking, i found that *** model.sol('sol').runAll;*** is taking 95% of overall simulation time. can you please suggests me to reduce the time duration of simulations.
I am using regular mesh with minimal complexity. 

best regards
thanks
1 Reply Last Post May 13, 2024, 12:21 p.m. EDT
Dave Greve
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 months ago May 13, 2024, 12:21 p.m. EDT
Updated: 7 months ago May 13, 2024, 12:21 p.m. EDT

Be aware that some problems are just too big.

However based on your drawing it looks like you have six-fold symmetry. Use it.

Be aware that some problems are just too big. However based on your drawing it looks like you have six-fold symmetry. Use it.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content