Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Mass loss happened during tds simulation
Posted May 22, 2024, 11:00 a.m. EDT Computational Fluid Dynamics (CFD), Chemical Reaction Engineering, Physics Interfaces Version 6.2 0 Replies
Please login with a confirmed email address before reporting spam
Hi,
For now, I'm simulating tds (transport of diluted species in porous medium) to figure out the distribution of molecules in specific circumstance. In addition, I'm also trying to calculate mass out from the domain by integrating boundary fluxes at the boundaries over time and measure mass for each time point. So, ideally, the mass of molecules given at initial time point should maintain over time, but I could see mass loss over time.
Could you give me any assistance or comments? Thank you in advance!
Hello Seunggyu Kim
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.