Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Setting temperature initial condition at specific location
Posted Feb 6, 2013, 11:53 a.m. EST Fluid & Heat, Heat Transfer & Phase Change, Computational Fluid Dynamics (CFD), Porous Media Flow, Studies & Solvers Version 4.3 0 Replies
Please login with a confirmed email address before reporting spam
I'm trying to solve a porous media heat transfer problem. the geometry of the problem includes 10/200 meters rectangle, where I'm setting a linear temperature gradient by the following equation:
T=((10[m]-y)/10[m])*100 [K]+293.15[K]
which works fine, next I need to set at the middle node of the rectangle (at location x=100, y=5) a temperature perturbation different from the value imposed by the equation.
How do I do that?
I Hope I'm explaining myself well.
Best Regards
Hello Roi Roded
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.