Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Part of module

Posted Mar 24, 2013, 8:15 a.m. EDT Geometry, Studies & Solvers Version 4.3a 3 Replies

Zdeno Zitny
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Good day.

It is possible to create a report in which it was shown as part of the model?

Thank you.
3 Replies Last Post Mar 25, 2013, 8:14 a.m. EDT
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Mar 24, 2013, 2:51 p.m. EDT
Hi
Have you checked the Report node (last one) there are some video I believe too

--
Good luck
Ivar
Hi Have you checked the Report node (last one) there are some video I believe too -- Good luck Ivar
Zdeno Zitny
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Mar 25, 2013, 6:46 a.m. EDT
Thanks for the reply but I had something else in mind.
I have more objects in the model, and between then this coil.
I would like to create a report only for the coil.

Thank you.
Thanks for the reply but I had something else in mind. I have more objects in the model, and between then this coil. I would like to create a report only for the coil. Thank you.
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Mar 25, 2013, 8:14 a.m. EDT
Hi
once you have added a Report node, you get many sub nodes, you can modify these (add subtract ...) but I heve not heard of extracting only part a model into a specific (sub)report

--
Good luck
Ivar
Hi once you have added a Report node, you get many sub nodes, you can modify these (add subtract ...) but I heve not heard of extracting only part a model into a specific (sub)report -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content