Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

setting mass flow rate at inlet

Posted Jun 14, 2013, 4:53 p.m. EDT Computational Fluid Dynamics (CFD) Version 4.3b 2 Replies

Ahmed Suleiman
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,
Model description

I have a 3D laminar air flow inside channel whose cross section is rectangle. for BC ,
1- the inlet , mass flow rate boundary is set (kg/s),
2- the outlet , zero pressure p=0 pa
3- the all other boundaries are symmetry.

My problem:

When I run it, I have a problem with convergence , then eventually failed to find the solution

Thanks

Attachments:

2 Replies Last Post May 17, 2017, 5:18 p.m. EDT
COMSOL Moderator

Hello Ahmed Suleiman

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Александра Алиева
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago May 17, 2017, 10:05 a.m. EDT
Updated: 8 years ago May 17, 2017, 10:06 a.m. EDT
Hi!
I know that it's the old post, but I'll try to ask, because I have the same problem here. Did you find the solution?
Hi! I know that it's the old post, but I'll try to ask, because I have the same problem here. Did you find the solution?
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago May 17, 2017, 5:18 p.m. EDT
Hi

have you tried to either ramp up the flow, or add some more realistic initial conditions, as some average velocity and Poiseuille first estimate pressure drop across the channel as initial conditions ?

Starting a CFD model with "0" initial conditions and high inlet flow is tricky and not really "physical"

--
Good luck
Ivar
Hi have you tried to either ramp up the flow, or add some more realistic initial conditions, as some average velocity and Poiseuille first estimate pressure drop across the channel as initial conditions ? Starting a CFD model with "0" initial conditions and high inlet flow is tricky and not really "physical" -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content