Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Negative power of zero - error
Posted Jun 28, 2013, 10:17 a.m. EDT Modeling Tools & Definitions, Parameters, Variables, & Functions Version 5.2 0 Replies
Please login with a confirmed email address before reporting spam
I am attempting to model the continuous casting process of steel. The molten steel is poured in from the top of the geometry, it then enters the water cooled copper mould, and then it is subsequently water quenched. I am trying to model the heat flow (including solidification) and in the future, any thermal stresses incurring in the copper mould.
I am starting with a 2D planar geometry, using stationary turbulent conjugate heat transfer physics.
I keep getting the following error, and I cannot pin point the source of where the "negative power of zero" error is coming from.
I am a fairly new user, any advice on how to improve model will be greatly appreciated. Thank you.
Segregated group 1
Attempt to evaluate negative power of zero.
- Function: ^
Failed to evaluate expression.
- Expression: d(d((down(mod2.nitf2.rho)*down(mod2.nitf2.Cp)*mod2.nitf2.C_mu^0.25*sqrt(max(mod2.k2,0))*(mod2.nitf2.TWall-mod2.T2)*test(mod2.T2)/mod2.nitf2.Tplus)*(dvol),{test@13}),mod2.k2)
Attachments:
Hello ms660
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.