Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

how deal with overlapped faces and volumes?

Posted Mar 19, 2010, 11:16 a.m. EDT 0 Replies

Mazyar Amin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am going to simulate blood in a blood vessel. I need to create a cylinder as the blood flow domain. My question is that for the blood vessel (the wall) do I need to create a full solid cylinder, or a concentric (hollow) cylinder with inner diameter equal to the outer diameter of the blood domain? Although odd, perhaps when using a full solid cylinder, it can ignore the common faces and volume.

Your help is appreciated.
Manuel
0 Replies Last Post Mar 19, 2010, 11:16 a.m. EDT
COMSOL Moderator

Hello Mazyar Amin

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content