Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Internal error in geometry processing.

Posted Dec 18, 2013, 5:47 p.m. EST Heat Transfer & Phase Change, Geometry, Mesh Version 4.3, Version 4.3b 0 Replies

Tom Yu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Internal error code is 5018.

The error happened under the "Free Tetrahedral 1" category. Basically my model involves forced convection cooling on a flat plate, and the error pointed to the convective fluid domain. I suspect this is due to the interface of two materials or geometry.
0 Replies Last Post Dec 18, 2013, 5:47 p.m. EST
COMSOL Moderator

Hello Tom Yu

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content