Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Put if condition to stop simulation

Posted Feb 25, 2014, 1:39 p.m. EST Fluid & Heat, Heat Transfer & Phase Change Version 3.5a 0 Replies

Yaseen Al Waaly
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

May somebody can help with following question:

How can I put if statement to stop simulation iterations? for example I am running conjugate heat transfer I would like to stop simulation when the temperature reaches to 85C. I want to use this condition inside the comsol instead using the link with Mathlab.

Thanks
0 Replies Last Post Feb 25, 2014, 1:39 p.m. EST
COMSOL Moderator

Hello Yaseen Al Waaly

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content