Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Out of memory in mesh processing
Posted Apr 4, 2014, 10:11 a.m. EDT Heat Transfer & Phase Change Version 4.3a 0 Replies
Please login with a confirmed email address before reporting spam
I'm trying to simulate the heat transfer on a set of CdTe detectors, which are connected to chips that are heating. I have a big geometry (I have 8 detectors with the corresponding chips...) and the physics are not symmetric, since the chips do not heat with the same intensity in all directions. Therefore I have to construct all the geometry.
I made the mesh as small as I could in order to not to have out of memory problems but I do still have (I defined different mesh for all the different domains, boundaries and edges, and I made the mesh as small as I could one by one). My computer is running at 64 bits.
It is possible to do anything more in order to not to have out of memory problems?
Thank you in advance,
David
Hello David Fernandez Bosman
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.