Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Joining Edges (results)

Please login with a confirmed email address before reporting spam

Hello All,

I have a situation where I have a parametric sweep, and I get a couple of solutions (all having the same geometry). I can use the join operator to subtract the solutions and I get something that makes sense. The issue is when I try to apply the same approach to one of the boundaries. I define it via "edge 2D" and I can plot the any variable over the arc length of the edge, however when I try to subtract two edges (via join), they don't even show up in the "data" drop down.

Does any one have any insight into why this isn't working, or how to go about subtracting 2 line plots (asides from exporting them)?

Thanks,
Aaron R. Shifman

0 Replies Last Post May 2, 2014, 6:51 p.m. EDT
COMSOL Moderator

Hello Aaron Shifman

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.