Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Electric Circuit connection issue

Posted May 31, 2014, 8:37 p.m. EDT Low-Frequency Electromagnetics Version 4.3b 1 Reply

chales
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Attached is a very simple copper parallel plate capacitor in air with no leads.

The upper face of the upper plate is defined as a TERMINAL {term1}-CIRCUIT

In the circuit module I create a Ivs.U and it wont let me select the ec/term1.

Why not?

Thanks in advance.

Colin

Attachments:

1 Reply Last Post Jun 3, 2014, 5:00 a.m. EDT
Jens Krause
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Jun 3, 2014, 5:00 a.m. EDT
Comsol gets confused, because you have two "Terminal names" with the same name "1".

Regards

Jens
Comsol gets confused, because you have two "Terminal names" with the same name "1". Regards Jens

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content