Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Parametric Sweep to Table

Please login with a confirmed email address before reporting spam

Hello all,

I have an ODE (w.r.t. time) defined on a few points and if I run the time dependent solver, I can use a point evaluation --> table and export the data no problem. However when I run a parametric sweep over top of the study and I use a numerical evaluation --> table after each iteration of the solver (parametric part) I get strange errors like

"numerical must be specified when storing table data" or
"incompatible numerical evaluation"

What does this mean, because I can't figure out what these errors are.

Thanks,
Aaron R. Shifman

0 Replies Last Post Oct 21, 2014, 9:57 a.m. EDT
COMSOL Moderator

Hello Aaron Shifman

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.