Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Periodic flow condition

Please login with a confirmed email address before reporting spam

Hi,
I am confused about how to use the periodic flow condition. I have a long and repeated geometry, and I want to model just one section of it (since it is repeated anyway).
Geometry is very simple (laminar incompressible flow in a tube) but, how do I specify initial conditions at the inlet, number of iteration and where the outlet flow goes back into the inlet?
Thank you in advance

1 Reply Last Post Jul 1, 2017, 4:02 p.m. EDT
COMSOL Moderator

Hello Valentina Nappo

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.


Please login with a confirmed email address before reporting spam

Posted: 7 years ago Jul 1, 2017, 4:02 p.m. EDT
Hi Nappo, I have the same problem as you. I am wondering have you solved the problem?
Hi Nappo, I have the same problem as you. I am wondering have you solved the problem?

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.