Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Heat transfer

Posted Dec 8, 2014, 4:05 p.m. EST Heat Transfer & Phase Change, Modeling Tools & Definitions, Parameters, Variables, & Functions Version 4.4 0 Replies

Karan Bikkannavar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am trying to simulate Joule Heating analysis on a 2d geometry. After running the simulation, I observe that there is no heat conduction through all surfaces!
Geometry- four curved surfaces as shown in the attached file. Note that there is an identity pair formed due to Assembly formation.(Please check the comsol file )
Results show no conduction or heat transfer through surface 2.. In real, it should!

May I please know what changes should be made.
0 Replies Last Post Dec 8, 2014, 4:05 p.m. EST
COMSOL Moderator

Hello Karan Bikkannavar

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content