Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Rotordynamics Problem

Posted Mar 11, 2015, 12:46 p.m. EDT 2 Replies

Sam Fisher
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello I wanted to obtain Campbell diagram for the given geometry (image attached). As I am new to COMSOL I wanted to know what is a good starting point to solve this problem.

Attachments:

2 Replies Last Post Mar 12, 2015, 1:33 p.m. EDT
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 9 years ago Mar 12, 2015, 3:29 a.m. EDT
Hi,

Search In the Model Library for the model rotating_blade. This model contains an example of a Campbell diagram.

Regards,
Henrik
Hi, Search In the Model Library for the model rotating_blade. This model contains an example of a Campbell diagram. Regards, Henrik
Sam Fisher
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago Mar 12, 2015, 1:33 p.m. EDT
Thank you Henrik I checkout the problem, and know how to do rotordynamic analysis, but I am more concerned about how to setup simply supported beam boundary conditions at the end of the shaft. The example is of a cantilever beam (Fixed at one end) in my case the ends are supported by bearings (which I assume as simple supports.

Regards
Thank you Henrik I checkout the problem, and know how to do rotordynamic analysis, but I am more concerned about how to setup simply supported beam boundary conditions at the end of the shaft. The example is of a cantilever beam (Fixed at one end) in my case the ends are supported by bearings (which I assume as simple supports. Regards

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content