Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Plotting a 3D Mirror Data Set to view Particle Trajectories- ERROR

Please login with a confirmed email address before reporting spam

Hi,

I have modelled half a pipe with particle trajectories in it, but I want to view the particle trajectories in the whole pipe. I tried doing so by creating a 3D Mirror Data Set.

I created a 3D Mirror Data Set and selected the particle trajectory (Particle 3) as the Data Set. The 3D Mirror of the pipe is plotted and is fine. The problem is when I change the data set for Particle Trajectories (fpt) into "Mirror 3D 2" instead of "Particle 3" and then in the sub-section, Particle Trajectories 1, I change the data set into "From Parent". I get an error:

Error: Operation cannot be performed on data set mir2(Mirror 3D).

Does anyone know the reason for that?

Thanks a lot

0 Replies Last Post Apr 21, 2015, 2:23 p.m. EDT
COMSOL Moderator

Hello Nadine Hassan

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.