Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

parameter values in a single plot.....

Please login with a confirmed email address before reporting spam

Hi every one, I want to measure the change in magnetic flux density at different values of the same parameter. For this i used parametric sweep that gives me accurate values but it runs the whole file for each value of the parameter as depicted in the attached file.

In the attached image there are three curves for three values of a parameter 'y'. The peak values are at y= 0.1, 0.3 and 0.5. For each there is a separate graph. I want it to be a single graph showing peak values at 0.1, 0.3 and 0.5. Plz could anyone help me with this... Thanks...


0 Replies Last Post May 13, 2015, 5:10 a.m. EDT
COMSOL Moderator

Hello Aamir Qamar

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.