Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to remove the waviness in MISES STRESS curve

Please login with a confirmed email address before reporting spam

Hi,

Recently I simulate an elastic-plastic model in solid mechanics module. When I get the mises stress curve, as shown in fig.Mises. I found there are many waves on the curve. How can I avoid this waviness?

I have tried high order shape function(cubic) and the waviness becomes less obvious. However, I cannot use much higher(like quartic) because of the convergence problem. So I want to know is there other ways to avoid this waviness? Thanks!

Best,
Rong


2 Replies Last Post May 18, 2015, 3:30 p.m. EDT
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 9 years ago May 18, 2015, 10:23 a.m. EDT
Hi,

This is a postprocessing artifact. There are two things you can do:

1. Specifically for stresses in structural mechanics: Plot results at Gauss points instead (solid.misesGp, for example).

2. Generally, in the Quality section of the result nodes (like Line Graph or Surface Plot), set Resolution to 'No Refinement'.

Regards,
Henrik
Hi, This is a postprocessing artifact. There are two things you can do: 1. Specifically for stresses in structural mechanics: Plot results at Gauss points instead (solid.misesGp, for example). 2. Generally, in the Quality section of the result nodes (like Line Graph or Surface Plot), set Resolution to 'No Refinement'. Regards, Henrik

Please login with a confirmed email address before reporting spam

Posted: 9 years ago May 18, 2015, 3:30 p.m. EDT
Hi Henrik,

Thanks so much. It is very useful. Now the curves looks much smoother.
Through your way, I remove the refinement in postprocessing so that the Runge's phenomenon would not appear again. Thank!

Best,
Rong
Hi Henrik, Thanks so much. It is very useful. Now the curves looks much smoother. Through your way, I remove the refinement in postprocessing so that the Runge's phenomenon would not appear again. Thank! Best, Rong

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.