Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

"Extrusion" along a predetermined path

Posted May 17, 2015, 4:43 p.m. EDT Version 5.0 2 Replies

David Baldwin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Can a 2D work-plane be "extruded" into 3D along a predetermined 3D curve, and If so, how?
2 Replies Last Post May 18, 2015, 11:46 a.m. EDT
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 9 years ago May 18, 2015, 11:10 a.m. EDT
Hi David,
If I understand you correctly, you're trying to sweep a face along a curve, see Reference Guide manual, version 5.1, page 441 and following.
Best,
Jeff
Hi David, If I understand you correctly, you're trying to sweep a face along a curve, see Reference Guide manual, version 5.1, page 441 and following. Best, Jeff
David Baldwin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago May 18, 2015, 11:46 a.m. EDT
thanks, I had figured it out.
thanks, I had figured it out.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content