Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
How to add inertial lift force, dean forces in particle tracing module?
Posted May 25, 2015, 10:02 a.m. EDT Fluid & Heat, Computational Fluid Dynamics (CFD), Microfluidics, Geometry, Mesh, Modeling Tools & Definitions, Parameters, Variables, & Functions 2 Replies
Please login with a confirmed email address before reporting spam
I'm working on a curved microfluidic channel and trying to use it to separate two particles.
However, when I use the particle tracing module, I could not find where to add the interial lift force and dean forces.
Could anyone help?
Thank you in advance!
Cecelia
Hello Zheng Dai
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
I m also facing the same problem. Did you got any solution for this. I tried to add them in particle tracing-> Forces -> expressions for lift forces. Still no use.
Looking for anybody who can suggest some good idea.
Thanks
Please login with a confirmed email address before reporting spam
I have the same problem that I could not add inertial lift force and Dean force. I tried inputting lateral
force but it seemed no use. And I still wonder how to figure out adding the Dean force.
Have you figured it out? I wish we could discuss on this.
Regards
Joel