Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Mesh & Tolearance question for fixed bridge design
Posted May 27, 2015, 12:01 p.m. EDT MEMS & Nanotechnology, MEMS & Piezoelectric Devices, Geometry, Mesh, Studies & Solvers, Structural Mechanics Version 5.1 0 Replies
Please login with a confirmed email address before reporting spam
I design a two side fixed bridge. The bridge length = 7mm, bridge width = 1mm, bridge height = 1um. I want to get a plot for displacement vs frequency. Right now I have two problems with these geometry. Firstly, it takes half hour to mesh the structure. If I use less fine, it turns out an error that I have to use extremely fine to mesh it. Once I get resonant frequency by using eigenfrequency study, I can set up the range for frequency domain study. If I set up the range to big, I will get an error said relative tolerance is smaller than the error or something related to tolerance. If I increase the tolerance, my plot won't be accurate. Does some one know how to fix these two problems?
Hello Wenyuan Zhu
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.