Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Microstrip Modeling, lumped port problem

Please login with a confirmed email address before reporting spam

Hello,

I am a new COMSOL user. I am trying to model a grounded 3D microstrip. To study its s11, s12, ... parameters, I need to use ports to excite the microstrip. I used uniform lumped ports at each end of the microstrip. The microstrip is made of copper and i put a transition boundary condition on the face in contact with the dielectric material underneath it. the ground is represented by a perfect electric conductor on the opposed face of the dielectric.
Still, COMSOL doesn't want to do the study as "the uniform lumped port must be between 2 conductive boundaries"
Why ?

Thank you

1 Reply Last Post Jun 2, 2015, 3:12 p.m. EDT

Please login with a confirmed email address before reporting spam

Posted: 9 years ago Jun 2, 2015, 3:12 p.m. EDT
It looks like you need to add a boundary material for the copper strip. Try that and see it the error goes away. You may have a TBC defined but if you don't have a material that goes with it, this error will pop up.
It looks like you need to add a boundary material for the copper strip. Try that and see it the error goes away. You may have a TBC defined but if you don't have a material that goes with it, this error will pop up.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.