Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
"Empty Expression"
Posted Jun 4, 2015, 4:00 p.m. EDT Mesh Version 5.0 1 Reply
Please login with a confirmed email address before reporting spam
I am trying to run a Free Tetrahedral mesh on a project I've designed. However, when I attempt to add a distribution to the simulation, it refuses to and gives a pop-up error of "Empty Expression."
Any idea why it is doing that? Thanks.
Any idea why it is doing that? Thanks.
1 Reply Last Post Jun 7, 2015, 12:44 p.m. EDT
Please login with a confirmed email address before reporting spam
Posted:
9 years ago
Hi
Normally that means an required entry is all empty (normally you leave a "0" or a "1" or something relevant in ALL model tree field entries).
Or it means you have forgotten to define the Entities on to which your Distribution applies, these are different (or might be) from the ones of the main mesh node
--
Good luck
Ivar
Normally that means an required entry is all empty (normally you leave a "0" or a "1" or something relevant in ALL model tree field entries).
Or it means you have forgotten to define the Entities on to which your Distribution applies, these are different (or might be) from the ones of the main mesh node
--
Good luck
Ivar