Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

lid-driven cavity flow problem

Please login with a confirmed email address before reporting spam

I am trying to solve the classical lid-driven cavity flow problem by Comsol, using Laminar module. However ,the moving wall condition is new to me, i just set the upper wall velocity at 1m/s, but can not find the solution. Comsol help file specify the necessary of "moving mesh". Can anyone who is familiar with the problem give me some advice? Thanks

2 Replies Last Post Jun 29, 2016, 2:50 p.m. EDT
COMSOL Moderator

Hello Tracy Zhu

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.


Please login with a confirmed email address before reporting spam

Posted: 8 years ago Jun 29, 2016, 11:32 a.m. EDT
Hello tracy,

I found your post today. The same problem is for me and am also new to this field. Can you help me now if you have found the solution for lid driven cavity flow?
Hello tracy, I found your post today. The same problem is for me and am also new to this field. Can you help me now if you have found the solution for lid driven cavity flow?

Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 years ago Jun 29, 2016, 2:50 p.m. EDT
See www.comsol.com/community/forums/general/thread/117651/#p261852 .
Jeff
See https://www.comsol.com/community/forums/general/thread/117651/#p261852 . Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.