Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Implementing a different boundary condition at each node using Matlab Livelink

Posted Sep 27, 2010, 4:25 p.m. EDT 0 Replies

Devin Pellicone
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello Everyone,

I am trying to simulate flow boiling in a microchannel using the Matlab Livelink. I have a Matlab finite difference code that solves for the heat transfer coefficient at each node along the channel for the the fluid, and I would like to apply this heat transfer coefficient as a boundary condition at each node in the solid model. Is there a way to apply different bounday conditions at different nodes along a surface?

Thanks for your help!

Devin
0 Replies Last Post Sep 27, 2010, 4:25 p.m. EDT
COMSOL Moderator

Hello Devin Pellicone

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content