Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Get force vs frequency plot for cantilever beam

Posted Dec 13, 2015, 12:41 p.m. EST MEMS & Nanotechnology, MEMS & Piezoelectric Devices, Results & Visualization Version 5.0 0 Replies

Manal Rafique
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I'm using eigenfrequency domain analysis for a cantilever beam with length :300um ,breadth : 40um, height : 7um . I'm suppose to get different frequency values for forces applied on the cantilever . How do I apply the force ? I have tried to apply a force of 20uN acting upon the cantilever using a point load , but and did parametric sweep for a range of forces but when I plot graph for force vs frequency , I don't get the correct values. How do I get different frequency values , for a range of forces applied ?
0 Replies Last Post Dec 13, 2015, 12:41 p.m. EST
COMSOL Moderator

Hello Manal Rafique

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content