See How Multiphysics Simulation Is Used in Research and Development
Engineers, researchers, and scientists across industries use multiphysics simulation to research and develop innovative product designs and processes. Find inspiration in technical papers and presentations they have presented at the COMSOL Conference. Browse the selection below or use the Quick Search tool to find a specific presentation or filter by application area.
View the COMSOL Conference 2023 Collection
Surface discharge initiation and propagation on the surface of an insulating solid immersed in a dielectric liquid were examined numerically and experimentally. To establish a generalized numerical technique for evaluating surface discharge phenomena using the electrohydrodynamics (EHD) ... Read More
In this paper, the "Morton Effect" is analyzed. This phenomenon is a particular kind of rotor instability due to non-uniform journal bearing heating. In this paper, an overview of the previous works has been done. After this preliminary study, a specific approach suggested by the ... Read More
COMSOL Multiphysics® software was used to model radial source flow in two dimensional homogeneous porous media. Two-Phase Darcy's Law (tpdl) is used to model miscible viscous fingering. Fingering patterns obtained on using different mesh are discussed. Evolution from 'flowers' to ... Read More
Wear in hydrodynamic journal bearings resulting from solid contact in the mixed friction regime becomes an increasingly prominent topic leading to the necessity of numerical wear evaluations. A numerical method tackling this topic based on Archard’s wear law is presented and applied on a ... Read More
Uncertainty appears in many aspects of physical simulations including stochastic design parameters, hard-to-specify input distributions, probabilistic boundary and initial conditions, and unknown geometries. Uncertainty Quantification (UQ) has emerged as the science of quantitative ... Read More
INTRODUCTION: Active cooling systems represent a possible solution to the electronics overheating that occurs in downhole tools operating on wireline, a cabling technology used to remotely control the downhole devices during oil and gas well interventions, in high temperature wells (150 ... Read More
In the Ball End Magneto rheological Finishing, due to heat generation by thermal agitation the effect of MRF finishing reduces and this ultimately hampers the process of the precision finishing and density of MR fluid too, which therefore results in instability of MR fluid. Read More
Technologies based on micro electro mechanical systems (MEMS) present advantages for rheological applications as they enable the fabrication of smaller sensors with faster response times. In this work we propose fabrication parameters and simulation of a MEMS viscometer. This research ... Read More
Recently, increasing availability of natural gas, due to the shale gas, raises the attention to the conversion of methane. Methanol-to-Hydrocarbons reaction (MTH) plays an important role in this route where methanol synthesized through syngas is converted into hydrocarbons, such as ... Read More
The CROWN project is a collaboration between 8 partners (LIC Energy, TWI, EDF Energy, DONG Energy, ORE Catapult, Wilton Engineering, Universal Coating, Metallisation) that is born from the offshore wind (OW) industry interest in the potential of Thermally Sprayed Aluminium (TSA) as ... Read More