See How Multiphysics Simulation Is Used in Research and Development
Engineers, researchers, and scientists across industries use multiphysics simulation to research and develop innovative product designs and processes. Find inspiration in technical papers and presentations they have presented at the COMSOL Conference. Browse the selection below or use the Quick Search tool to find a specific presentation or filter by application area.
View the COMSOL Conference 2023 Collection
COMSOL Multiphysics® coupled with Solidworks® is employed to design, simulate and fabricate cartridges for a materials printer to accomplish in-situ curing of UV curable ink patterns as they are printed on flexible media for printed electronic circuit manufacturing. The cartridges ... Read More
In this paper, PEM fuel cells with serpentine and interdigitated flow channel patterns were studied. The main objective was to analyze the influence of the flow channel design in the current distribution over the cell. A 3D isothermal model comprising the entire 5 cm² cell was developed ... Read More
In this contribution we study how a planar photonic crystal waveguide (PhCW), created by introducing a line defect in the photonic crystal, can modify the projected local density of states (LDOS) for a dipole emitter. We use the COMSOL Multiphysics® RF Module to carry out eigenvalue ... Read More
Surface acoustic wave (SAW) devices are widely used for their sensing capabilities and gas sensing is only one of many uses. There is an ever increasing need to make them as effective as possible by adding nanomaterials to the device. In this study a two-port delay-line structure with ... Read More
After rapid mixing of waste water and coagulant, an effective slow mixing during a reasonable retention time will cause to grow the size of flocs up which will settle out easily. Around-the-end hydraulic mixer with barriers is one of the efficient facilities that have been used in water ... Read More
This paper presents steady and unsteady computational results obtained from numerical solutions of the full two-dimensional governing equations for annular internal condensing flows in a channel. This is achieved by tracking the “sharp” interface while solving the flow fields using ... Read More
This paper describes how to numerically tackle the problem of counting and sizing particles by impedance measurement in an orifice–electrode system. The model simulate the particle dynamics submitted to strong hydrodynamic stresses through a microorifice and compute the voltage pulses ... Read More
Single coil actuators are representing one important component of ABB’s medium voltage reclosers. Their performance is strongly influenced by the considered material properties as well as by the electronic control units’ properties that will power the actuator. Therefore, this paper ... Read More
Fuel bundles in the CANDU (CANada Deuterium Uranium) reactor are designed for heating a pressurized coolant (heavy water) to generate electricity. The designs for the fuel bundles differ based on the number of heating elements. The flow of heavy water over the elements and inside the ... Read More
An alluvial aquifer system has probably conceived as a numerical modeling hell. We have chosen COMSOL Multiphysics® for two reasons: 1) FEM methods allow to use complex geometries; 2) multiphysics simulation permits to run a single model with all phenomena. We built a section with these ... Read More