Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Why could't I mesh the geometry?

Please login with a confirmed email address before reporting spam

Hi,

I have tried a lot and read the help manual but still could not find solutions.

I have created the intersecting pipes model (inside) which was imported from Pro/E (we perchased the CAD Import module) and a block (ourside) which was created in Comsol.

I tried to mesh it but it did not work. The comsol alway pops out error: Internal geometry error!!

Do you have any advices? Thanks very much.



1 Reply Last Post Mar 10, 2011, 1:02 a.m. EST
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Mar 10, 2011, 1:02 a.m. EST
Hi

it all depends on the geometry, there are many help instructions in the KB as well on the forum + the examples in the doc. Meshing is an "art" an requires some experimenting

--
Good luck
Ivar
Hi it all depends on the geometry, there are many help instructions in the KB as well on the forum + the examples in the doc. Meshing is an "art" an requires some experimenting -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.