Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

sweep/map meshing couette flow

Please login with a confirmed email address before reporting spam

Hi, I have the attached geometry and am trying to customize my mesh. The gap between the rotating cylinder(internal) and external boundary wall is very small to prevent secondary flow and this is where my point of interest is. It becomes too heavy for my RAM to handle if I keep a tetrahedral mesh in this location. I am trying to only have brick mesh components in this section, yet when I try to either map or sweep this area it errors out. Please let me know if you may have some recommendation on how to only have brick components in this region.

Thanks!
Mike


0 Replies Last Post Jul 2, 2016, 1:25 p.m. EDT
COMSOL Moderator

Hello Michael Pozin

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.