Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Failed to find Consistent Initial Values

Posted Jul 13, 2016, 7:00 p.m. EDT Fluid & Heat, Computational Fluid Dynamics (CFD), Porous Media Flow, Geometry Version 5.1, Version 5.2 0 Replies

Femi Oyedokun
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am solving a turbulent flow problem in Comsol; and I've been having non-convergence issues. I have used small initial values; and I have also used a ramp function with steady state value of the inlet flow parameters, but the error still persists. The mesh is not coarse, the boundary conditions were well specified. Please, I will appreciate suggestions on how I can tackle the problem.

Regards

Femi
0 Replies Last Post Jul 13, 2016, 7:00 p.m. EDT
COMSOL Moderator

Hello Femi Oyedokun

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content