Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Super simple geometry- self intersection when meshing 5.2.a

Posted Feb 3, 2017, 9:09 a.m. EST Low-Frequency Electromagnetics, Geometry, Mesh Version 5.2a 2 Replies

Gert Persson
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Super simple geometry created using sweep-command
The mesh wont work - self intersection!
I really don't understand how I should create this geometry, is there something I don not understand when it comes to the sweep-command?

Attachments:

2 Replies Last Post Feb 4, 2017, 9:54 a.m. EST
Peter Chang
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 years ago Feb 3, 2017, 4:49 p.m. EST
Because the way you set up your geometry is self intersecting. Please see the attached file with my geometry sequence.
Because the way you set up your geometry is self intersecting. Please see the attached file with my geometry sequence.

Attachments:

Gert Persson
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 years ago Feb 4, 2017, 9:54 a.m. EST
Thank you Peter!
Extrude and Revolve works fine, I understand that Sweep is not suitable for this.
Thank you Peter! Extrude and Revolve works fine, I understand that Sweep is not suitable for this.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content