Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Connect SMA conectors to MW source

Posted May 19, 2017, 11:54 a.m. EDT 1 Reply

Josef Soucek
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello

Please, id like examinate microwave propagation in sma connector pcb mount. (from comsol library). I connected lumped port on middle circle and make inner and outer cylinder like perfect electric conductor, but there is still error "Uniform lumped port should be placed between two conductive boundaries."
Do you know where can be probleme? This is same when I make all boundaries like perfect electric conductor, probleme is still here.

Thanks a lot for advice
1 Reply Last Post May 19, 2017, 2:23 p.m. EDT
Dennis Brown
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago May 19, 2017, 2:23 p.m. EDT
Change from uniform to coaxial in the drop down menu for the lumped port.
Change from uniform to coaxial in the drop down menu for the lumped port.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content