Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Inverted mesh point at a point wher virtually nothing is going on.
Posted May 6, 2012, 7:05 p.m. EDT 0 Replies
Please login with a confirmed email address before reporting spam
Warning: Inverted mesh element near coordinates (-2.84755e-025, -4.9111e-011),
While I am using a very small model of a tube basically with dimentions 100nmx100um, the point mentioned above is in the middle of a area where nothing of importance is happenening and should be essentially at steady state. I would better define the mesh at that area but that I dont think is the problem.
I am modeling electrodeposition in a nano pore so it may and am basically following the copper deposition model with a few minor changes. Any suggestions would be appreciated.
Thank
Hello Matt Hein
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.