Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

meshing problem

Please login with a confirmed email address before reporting spam

I am trying to model a permanent magnet in 3D. geometry for the model is quite simple, but for this geometry, COMSOL is not able to mesh with free mesher. With swept or mapped, mesh mesh quality is poor. Please give some suggestion.


0 Replies Last Post Feb 24, 2010, 7:40 a.m. EST
COMSOL Moderator

Hello vijay sharma

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.