Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Too high a pressure causing initial problems

Posted Jul 24, 2014, 11:45 a.m. EDT 0 Replies

Matthew James
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

I am trying to use the model in the model library called "in plane microwave plasma" but I would like to run it at a high pressure (1 atm). Whenever I do this, the model says "Failed to find consistent initial values, last time step not converged". I am not asking the model to jump from 0 pressure to 1 atm, as I have set the initial pressure as 1 atm. Does anyone know how I can fix this?

Thanks
0 Replies Last Post Jul 24, 2014, 11:45 a.m. EDT
COMSOL Moderator

Hello Matthew James

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content