Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Auxilary Sweep starting at 0.0

Please login with a confirmed email address before reporting spam

Hi

I have a stationary solid mechanics model that involves large displacements and uses hyper-elastic materials etc.

Setting up a "Parametric sweep" node under "Study" I am finding that some configurations run fine with a auxiliary sweep "range(0.0[psi],5.0[psi],100[psi])" whilst some stop with no error or results but will run using "range(0.1[psi], 5.0[psi],100[psi])" ...what could be the possible reasons for this?

Thanks Colin

0 Replies Last Post Mar 26, 2015, 7:39 a.m. EDT
COMSOL Moderator

Hello Blighty

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.